• 01. If your nails are long, cut them and measure them as close to when you will be using nail tips.

    ・If you have gel nails or plan to use it on top of gel nails, please let us know.

  • 02. Place the measuring tip on your nail and select the size.

    ・Choose a size that fits your nails perfectly without touching the skin. Do not press down too hard on the nail (as applying gel will make the curve tighter and prevent it from bending).

    If you are unsure about the size, try sticking it on using the included adhesive tape.

    ☑︎0.25mm: If you don't mind the gap between the tip and the nail

    ☑︎0.5mm: When there is a large gap between the tip and the nail

    ​・If the measurement tip feels too tight, it may be too small.

Make sure the light is good, the shot is straight, and not out of focus.

What should I do in this situation?

  • Gaps at the base of the nail
     This may be improved by straightening the roots . Please check the finger you would like on the size sheet.

    ​

    I have to press hard to stick it on / It hurts my nails when I stick it on

    The curve of the tip may not match the nail. This is often because the nail is flat.

    01. Try the 5mm thick adhesive tape (included with the measurement chip)

    02. Apply adhesive tape over the nail, imagining that you are filling in the gap between the nail and the tip.

    03. Flattening

    This can be avoided by taking measures such as

    If using tape is not sufficient, please contact us to request flattening.

    ​

    The tip is long

    Please enter the length you want to cut in 1mm increments in the size measurement table.

    *Please note that there may be slight differences due to manual adjustment.

    * Because the tip is cut to fit the tip side, if the almond type is cut significantly, it will have a gentle curve from the tip to the side and become rounded.

Chip processing service information

We will look at a photo of your natural nails and may recommend the following treatments if necessary.
We also welcome requests from customers.
We can flexibly accommodate each customer's needs, even if they are not listed here. Please feel free to contact us.

01. Straightening the base

The base of the tip is shaved down and straightened to fit the base of the finger.

​It may be possible to reduce the gap at the base corner.


This is the most commonly used service for people with straight thumb bases.

We can also treat fingers other than the thumb.

*Approximately 2mm shorter

02. Flat processing

Apply heat to loosen the curve on the tip for a better fit.
Recommended for flat or curved nails. First, try using two layers of adhesive tape, and if that doesn't work, please contact us.
*Since the product will expand horizontally after processing, you will need to press it down firmly to measure the size.
Please contact us for more information

03. Length adjustment

​Cut the tip to the desired length.

You can measure the length you want to shave along the curve with a flexible tape measure and specify it in 1mm increments. Fill out the size chart and send it to LINE.

​
*The length cannot be adjusted. *There may be slight variations due to manual work.